| |
 Specification
- Chipset:
Northbridge: ATi Radeon 9100 IGP (RS300)
Southbridge: IXP150 - Socket 478 CPU support
Intel Pentium 4 and Celeron processor with Socket 478
supports 400, 533 and 800MHz FSB with Hyper-Threading support - Expansion slots:
1 x AGP (v3.0) slot supports 8X and 4X mode
Important note: AGP slot supports 1,5V mode only (3,3V is not supported)
3 x 32 Bit PCI (v2.2) - Onboard IDE Controller
2-Channel enhanced PCI IDE
to 4 IDE devices
supports UltraDMA/100 - Multimedia:
6-Channel AC97 rev. 2.2 sound function
Realtek ALC650
connectors on the backpanel: line-in, line-out, micorphone
onboard: 2x CD-in, SPDIF in/out - Networking:
supports 10/100MBit/s LAN with WOL function
Broadcom BCM4401KFB Chipet
RJ45 network connectors on the backpanel - Backpanel-Connectors
1 x PS/2 Mouse
1 x PS/2 Keyboard
1 x VGA
1 x Serial
1 x Parallel (SSP/EPP/ECP)
4 x USB 2.0 (further two onboard)
Audio: line-in, line-out, micorphone - Onboard-Connections:
1 x Floppy drive
2 x USB 2.0 (further four on the backpanel)
Frontpanel sound connectors
SPDIF in/out
2 x CDROM audio-out
Fan-voltage supply - Memory:
two 184-Pin DIMM memory sockets
for PC1600 (DDR200), PC2100 (DDR266), PC2700 (DDR333) or PC3200 (DDR400)
of unbuffered DDR SDRAM memory
with 100, 133, 166 or 200MHz clock frequency
up to 2 GB Dual-channel capacity - Hardware monitoring
CPU-temperature, voltages and fan revolution - Power management
ACPI Version 1.0 (Advanced Configuration and Power Interface)
supports power saving modes: S1 (Snoop), S3 (Suspend to RAM), S4 (Suspend to DISK), S5 (Soft-Off) - BIOS
PnP Green BIOS stored in 2MBit Flash memory chip - ATX-power supply-connector
Standard 20-Pin-ATX power supply connector + 4 Pin connector for 12Volt - Delivery Content
Manual, driver-CDROM, backpanel-bracket, USB- and floppy drive cable - Form Factor
MicroATX: 24 x 24 cm
| Navigation |
 |
|
Home
MT63
